Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY › 2012.12–2014.10
RM3090E _58 Vehicle Interior _008788 SEAT BELT _0050326 FRONT SEAT INNER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT INNER BELT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 73240 1.INSTALL FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)

a.
B334882C01
0.792,2.896 1,3.167 1,3.167 1.667,3.167 true 1.708,3.083 2.021,3.281 0.313,0.198 10 *1
*1 Protruding Part


Install the front seat inner belt assembly with the nut.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTICE:

Do not allow the anchor of the front seat inner belt assembly LH to overlap the protruding part of the separate type front seat cushion spring assembly.



b.

Connect each connector and each clamp.


c.
B334879

Return the separate type front seat cushion cover to its original position.


Hide 73230 2.INSTALL FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)

a.

w/o Occupant Detection ECU:

i.

Use the same procedure as for the driver seat.

Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY>INSTALLATION



b.
B339090C01
1.906,2.031 2.427,2.031 2.427,2.031 2.688,1.552 true 1.708,1.969 2.021,2.125 0.313,0.156 10 *1
*1 Protruding Part


w/ Occupant Detection ECU:

i.

Install the front seat inner belt assembly with the nut.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)

NOTICE:

Do not allow the anchor of the front seat inner belt assembly RH to overlap the protruding part of the separate type front seat cushion spring assembly.



ii.

Attach the guide to install the limit switch of the front seat inner belt assembly.


iii.

Install the screw.


iv.
B339088

Return the separate type front seat cushion cover to its original position.


v.

Connect each connector and each clamp.


vi.

Attach the 2 guides and 2 claws to install the front set inner cushion shield RH.