Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
87510N
1.INSTALL FRONT SEATBACK HEATER ASSEMBLY LH
Set the front seatback heater assembly LH on the separate type front seatback cover.
Using a tacker, install the front seatback heater assembly LH to the separate type front seatback cover with 14 new tack pins as shown in the illustration.
Do not substitute other metal parts for tack pins.
71074S
2.INSTALL SEPARATE TYPE FRONT SEATBACK COVER
71931
3.INSTALL FRONT SEAT HEADREST SUPPORT
4.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY
71862
5.INSTALL FRONT INNER SEAT CUSHION SHIELD LH
71812D
6.INSTALL FRONT SEAT CUSHION SHIELD LH
71868A
7.INSTALL FRONT INNER NO. 1 SEAT CUSHION SHIELD LH
8.INSTALL FRONT SEAT ASSEMBLY LH
9.INSPECT SEAT HEATER SYSTEM