Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › 2012.12–2015.10
RM3090E _56 Audio / Visual / Telematics _008775 AUDIO / VIDEO _0048748 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Steering Pad Switch Circuit  


DESCRIPTION

This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly.

If there is an open in the circuit, the audio system cannot be operated using the steering pad switch assembly.

If there is a short in the circuit, the same condition as when a switch is continuously depressed occurs.

Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch assembly, and also the radio and display receiver assembly itself cannot function.

WIRING DIAGRAM

E269542E02
1.063,1.917 1.417,2.115 0.354,0.198 10 false Right 1.646,1.917 2,2.115 0.354,0.198 10 false Back 2.25,1.917 2.604,2.115 0.354,0.198 10 false Enter 0.479,1.917 0.833,2.115 0.354,0.198 10 false Left 0.271,0.833 0.854,1.021 0.583,0.188 10 false Volume- 1.708,3.083 2.708,3.25 1,0.167 10 false MODE/HOLD 4.271,0.594 4.51,0.771 0.24,0.177 10 false z1 6.167,0.563 6.531,0.76 0.365,0.198 10 false SW1 5.323,0.583 5.583,0.792 0.26,0.208 10 false G8 5.375,0.385 5.583,0.594 0.208,0.208 10 false 6 4.729,2.5 5.083,2.698 0.354,0.198 10 false AU3 1,3.833 2.917,4.063 1.917,0.229 10 false Steering Pad Switch LH Side 0.542,4.854 0.958,5.052 0.417,0.198 10 false Voice 2.01,4.865 2.583,5.063 0.573,0.198 10 false On Hook 0.865,0.833 1.458,1.021 0.594,0.188 10 false Volume+ 1.615,0.844 2.083,1.042 0.469,0.198 10 false Down 2.375,0.865 2.656,1.104 0.281,0.24 10 false Up 4.25,0.396 4.438,0.573 0.188,0.177 10 false 11 4.292,1.385 4.51,1.563 0.219,0.177 10 false 8 4.292,2.438 4.458,2.604 0.167,0.167 10 false 9 4.25,3.396 4.458,3.563 0.208,0.167 10 false 10 4.271,1.604 4.51,1.781 0.24,0.177 10 false z1 4.281,2.646 4.521,2.823 0.24,0.177 10 false z1 4.25,3.594 4.49,3.771 0.24,0.177 10 false z1 5.323,1.594 5.583,1.802 0.26,0.208 10 false G8 5.323,2.625 5.583,2.833 0.26,0.208 10 false G8 5.302,3.594 5.563,3.802 0.26,0.208 10 false G8 5.375,1.396 5.542,1.604 0.167,0.208 10 false 3 5.365,2.417 5.531,2.625 0.167,0.208 10 false 4 5.375,3.385 5.542,3.594 0.167,0.208 10 false 5 5.938,3.49 6.167,3.677 0.229,0.188 10 false 22 5.927,2.5 6.146,2.698 0.219,0.198 10 false 24 5.938,1.458 6.135,1.656 0.198,0.198 10 false 23 5.938,0.479 6.146,0.667 0.208,0.188 10 false 21 6.167,1.583 6.604,1.792 0.438,0.208 10 false SWG 6.156,2.625 6.573,2.792 0.417,0.167 10 false SW3 6.156,3.594 6.531,3.781 0.375,0.188 10 false SW2 5.917,4 6.271,4.198 0.354,0.198 10 false G143 5.938,4.167 7.146,4.76 1.208,0.594 10 false Radio and Display Receiver Assembly 4.49,4.021 5.49,4.354 1,0.333 10 false Spiral Cable Sub-assembly 1.219,4.865 1.792,5.063 0.573,0.198 10 false Off Hook 1,6.125 2.99,6.333 1.99,0.208 10 false Steering Pad Switch Assembly 0.958,5.635 2.875,5.865 1.917,0.229 10 false Steering Pad Switch RH Side 4.75,0.469 5.104,0.667 0.354,0.198 10 false AU1 4.729,1.469 5.083,1.667 0.354,0.198 10 false EAU 4.729,3.469 5.083,3.667 0.354,0.198 10 false AU2

CAUTION / NOTICE / HINT

NOTICE:

The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o Occupant Classification System)>PRECAUTION


PROCEDURE

1.INSPECT STEERING PAD SWITCH ASSEMBLY
a.

Remove the steering pad switch assembly.

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>REMOVAL


b.

Inspect the steering pad switch assembly.

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY


Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)

NG

3.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY)
a.

Disconnect the G143 radio and display receiver assembly connector.


b.

Disconnect the G8 spiral cable sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G143-21 (SW1) - G8-6 (AU1) Always Below 1 Ω
G143-22 (SW2) - G8-5 (AU2) Always Below 1 Ω
G143-23 (SWG) - G8-3 (EAU) Always Below 1 Ω
G143-24 (SW3) - G8-4 (AU3) Always Below 1 Ω
G143-21 (SW1) - Body ground Always 10 kΩ or higher
G143-22 (SW2) - Body ground Always 10 kΩ or higher
G143-23 (SWG) - Body ground Always 10 kΩ or higher
G143-24 (SW3) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR