Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat)
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0050514 FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

·

If the side airbag was deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.



HINT:
·

Use the same procedure for the driver side of RHD and LHD vehicles.

·

The procedures listed below are for the driver side of LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 73920A 1.INSTALL FRONT SEAT AIRBAG ASSEMBLY LH

a.

for Single Type:

CAUTION:
·

The nuts must not be reused.

·

Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.



i.

Install the front seat airbag assembly LH with 2 new nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


ii.

Attach the 2 clamps to the front seatback frame sub-assembly.



b.

for Dual Type:

CAUTION:
·

The nuts must not be reused.

·

Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.



i.

Install the front seat airbag assembly LH with 2 new nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


ii.

Attach the 2 clamps to the front seatback frame sub-assembly.



Hide 71552S 2.INSTALL SEPARATE TYPE FRONT SEATBACK PAD

Hide 71074S 3.INSTALL SEPARATE TYPE FRONT SEATBACK COVER

Hide 71931 4.INSTALL FRONT SEAT HEADREST SUPPORT

Hide 5.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 71862 6.INSTALL FRONT INNER SEAT CUSHION SHIELD LH

Hide 71812D 7.INSTALL FRONT SEAT CUSHION SHIELD LH

Hide 71868A 8.INSTALL FRONT INNER NO. 1 SEAT CUSHION SHIELD

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION