Home › Drivetrain › K111 MULTIDRIVE / CVT › DECELERATION SENSOR › 2012.12–2015.10
RM3090E _52 Drivetrain _008435 K111 MULTIDRIVE / CVT _0058108 DECELERATION SENSOR A

K111 MULTIDRIVE / CVT  DECELERATION SENSOR  INSTALLATION  


PROCEDURE

Hide 89441A 1.INSTALL DECELERATION SENSOR

a.

Install the deceleration sensor with the 2 bolts.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not damage the deceleration sensor.

·

Make sure that the deceleration sensor is installed securely.




b.

Connect the deceleration sensor connector.


Hide 89189B 2.INSTALL YAW RATE SENSOR BRACKET

a.

Install the bracket with the bolt.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


Hide 3.INSTALL FRONT DOOR SCUFF PLATE LH

Hide 4.INSTALL FRONT SEAT ASSEMBLY LH

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).