Use the following procedure to troubleshoot the parking assist monitor system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the navigation system (for Navigation Receiver Type).
Refer to the audio and visual system (for Radio and Display Type).
| Proceed to |
|---|
| Navigation system and audio and visual system are normal |
| Navigation system is abnormal |
| Audio and visual system is abnormal |
Navigation system and audio and visual system are normal
Navigation system is abnormal
Audio and visual system is abnormal
Use the GTS to check if the CAN communication system is functioning normally.
for LHD:
for RHD:
| Proceed to |
|---|
| CAN DTCs are not output. (w/ Power Back Door System) |
| CAN DTCs are not output. (w/o Power Back Door System) |
| CAN DTCs are output. (for LHD) |
| CAN DTCs are output. (for RHD) |
CAN DTCs are not output. (w/ Power Back Door System)
CAN DTCs are not output. (w/o Power Back Door System)
CAN DTCs are output. (for LHD)
CAN DTCs are output. (for RHD)
Check for DTCs.
Click hereVehicle Exterior>DOOR / HATCH>BACK DOOR CLOSER SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| Back door closer system DTCs are not output. |
| Back door closer system DTCs are output. |
Back door closer system DTCs are not output.
Back door closer system DTCs are output.
Check for DTCs and note any codes that are output.
Clear the DTCs.
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
The television camera assembly and navigation receiver assembly*1 or radio and display receiver assembly*2 outputs DTCs for the following systems. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.
*1: for Navigation Receiver Type
*2: for Radio and Display Type
| Proceed to |
|---|
| No DTCs are output. |
| DTC is output. |
No DTCs are output.
DTC is output.
Refer to the Problem Symptoms Table.
| Proceed to |
|---|
| Fault is not listed in Problem Symptoms Table |
| Fault is listed in Problem Symptoms Table |
Fault is not listed in Problem Symptoms Table
Fault is listed in Problem Symptoms Table
Data List / Active Test.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT