| The estimated course lines are not displayed.
|
Parking assist monitor screen display mode settings. (Check if the parking guide lines are set to off.)
|
|
| Steering angle setting
|
|
| Television camera assembly
|
|
| Navigation receiver assembly (for Navigation Receiver Type)
|
|
| Radio and display receiver assembly (for Radio and Display Type)
|
|
| Guide lines are not displayed for all parking assist monitor screen display modes.
|
Check if the back door is not closed
|
-
|
| Steering angle setting
|
|
| Back camera position setting
|
|
| Television camera assembly
|
|
| The guide lines remain displayed even though the back door is open.
|
Proceed to "Guide Lines are not Displayed for All Display Modes"
|
|
| Television camera assembly
|
|
| The guide lines do not display even though the back door is closed.
|
Proceed to "Guide Lines are not Displayed for All Display Modes"
|
|
| Television camera assembly
|
|
| The guide line switching screen is not displayed.
|
Television camera assembly
|
|
| Navigation receiver assembly (for Navigation Receiver Type)
|
|
| Radio and display receiver assembly (for Radio and Display Type)
|
|
| A guide line mode other than the one selected is displayed.
|
CAN communication system (for LHD)
|
|
| CAN communication system (for RHD)
|
|
| Television camera assembly
|
|
| Navigation receiver assembly (for Navigation Receiver Type)
|
|
| Radio and display receiver assembly (for Radio and Display Type)
|
|
| The button for the selected guide line mode does not change to the set color. A different button changes to the set color.
|
CAN communication system (for LHD)
|
|
| CAN communication system (for RHD)
|
|
| Television camera assembly
|
|
| Navigation receiver assembly (for Navigation Receiver Type)
|
|
| Radio and display receiver assembly (for Radio and Display Type)
|
|
| The display mode switch screen button cannot be pushed.
|
CAN communication system (for LHD)
|
|
| CAN communication system (for RHD)
|
|
| Proceed to "Speed Signal Circuit" in Meter / Gauge System
|
|