11401L
1.INSTALL REAR ENGINE OIL SEAL
Apply MP grease to the lip of a new rear engine oil seal.
Using SST and a hammer, tap in the rear engine oil seal as shown in the illustration.
0 to 0.9 mm (0 to 0.0354 in.)
Keep the lip free from foreign matter.
Do not tap the rear engine oil seal at an angle.
Make sure that the rear engine oil seal is properly installed.
13450
2.INSTALL FLYWHEEL WITH DAMPER ASSEMBLY
31250
3.INSTALL CLUTCH DISC ASSEMBLY
31210
4.INSTALL CLUTCH COVER ASSEMBLY
31210
5.INSPECT AND ADJUST CLUTCH COVER ASSEMBLY
30300
6.INSTALL MANUAL TRANSAXLE ASSEMBLY
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION