Home › Engine / Hybrid System › 2WW ENGINE CONTROL › ECD SYSTEM › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208480 ECD SYSTEM C

2WW ENGINE CONTROL  ECD SYSTEM  P1273  Learning Factor Too High  P1274  Learning Factor Too Low  


DESCRIPTION

Refer to DTC P0090.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>P0090

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P1273 Learning Factor Too High When rail pressure regulating adaptation valve falls below minimum threshold.
(3 trip detection logic)
Pressure discharge valve Does not come on DTC stored
P1274 Learning Factor Too Low When rail pressure regulating adaptation valve exceeds maximum threshold.
(3 trip detection logic)
Pressure discharge valve Does not come on DTC stored

Related Data List
DTC No. Data List
P1273
P1274
·

Rail Pressure Control Valve - Current Value from Rail Pressure Valve Control

·

Dutycycle Output of Rail Pressure Control Valve



WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

After replacing the pressure discharge valve, the ECM needs initialization.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>PRECAUTION


HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.REPLACE PRESSURE DISCHARGE VALVE ASSEMBLY
a.

Replace the pressure discharge valve assembly.

Click hereEngine / Hybrid System>2WW FUEL>FUEL PRESSURE DISCHARGE VALVE>REMOVAL


b.

Perform the fuel PCV compensation value reset.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>INITIALIZATION


Result:
Proceed to
NEXT



NEXT

2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
2.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.

Powertrain > Engine and ECT > Clear DTCs
50002 371

d.

Turn the ignition switch off and wait for 60 seconds or more [A].


e.

Perform road test [B].


f.

Repeat [A] and [B] for the number of trips detected.


g.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes
50001 371

h.

Confirm that the DTC is not output again.


Result:
Proceed to
NEXT



NEXT

END