51441
1.REMOVE NO. 1 ENGINE UNDER COVER
51443
2.REMOVE REAR ENGINE UNDER COVER RH
51444
3.REMOVE REAR ENGINE UNDER COVER LH
4.DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID
Remove the refill plug and gasket from the continuously variable transaxle assembly.
Using a 10 mm hexagon socket wrench, remove the drain plug and gasket from the transaxle oil (CVT) pan sub-assembly, and drain the fluid.
Install a new gasket and the drain plug to the transaxle oil (CVT) pan sub-assembly.
Temporarily install the gasket and refill plug to the continuously variable transaxle assembly.
Reuse the old gasket. The refill plug will be removed again to adjust the fluid level.
5.REMOVE FRONT DRIVE SHAFT ASSEMBLY
43457
6.REMOVE DRIVE SHAFT BEARING BRACKET
43420H
7.REMOVE FRONT DRIVE SHAFT OIL SEAL LH
Using SST, remove the front drive shaft oil seal LH from the continuously variable transaxle assembly.
Do not damage the continuously variable transaxle assembly.
43410M
8.REMOVE FRONT DRIVE SHAFT OIL SEAL RH
Using SST, remove the front drive shaft oil seal RH from the continuously variable transaxle assembly.
Do not damage the continuously variable transaxle assembly.
43420H
9.INSTALL FRONT DRIVE SHAFT OIL SEAL LH
Apply MP grease to the lip of a new front drive shaft oil seal LH.
| *a | -0.5 to 0.5 mm |
Using SST and a hammer, install the front drive shaft oil seal LH to the continuously variable transaxle assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Be sure to install the front drive shaft oil seal LH in the correct direction.
Make sure to install the front drive shaft oil seal LH as specified, otherwise malfunctions such as a fluid leak will occur.
Do not damage the lip of the front drive shaft oil seal LH.
43410M
10.INSTALL FRONT DRIVE SHAFT OIL SEAL RH
Apply MP grease to the lip of a new front drive shaft oil seal RH.
| *a | -0.5 to 0.5 mm |
Using SST and a hammer, install the front drive shaft oil seal RH to the continuously variable transaxle assembly.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Be sure to install the front drive shaft oil seal RH in the correct direction.
Make sure to install the front drive shaft oil seal RH as specified, otherwise malfunctions such as a fluid leak will occur.
Do not damage the lip of the front drive shaft oil seal RH.
43457
11.INSTALL DRIVE SHAFT BEARING BRACKET
12.INSTALL FRONT DRIVE SHAFT ASSEMBLY
13.ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID
14.INSPECT FOR FLUID LEAK
51443
15.INSTALL REAR ENGINE UNDER COVER RH
51444
16.INSTALL REAR ENGINE UNDER COVER LH
51441
17.INSTALL NO. 1 ENGINE UNDER COVER