51441
1.REMOVE NO. 1 ENGINE UNDER COVER
51444C
2.REMOVE REAR ENGINE UNDER COVER LH
3.DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID
Using a 6 mm socket hexagon wrench, remove the overflow plug and gasket from the continuously variable transaxle assembly.
| *1 | No. 1 Transmission Oil Filler Tube |
Using a 6 mm socket hexagon wrench, remove the No. 1 transmission oil filler tube from the continuously variable transaxle assembly and drain the continuously variable transaxle fluid.
Using a 6 mm socket hexagon wrench, install the No. 1 transmission oil filler tube to the continuously variable transaxle assembly.
Temporarily install the gasket and overflow plug.
Reuse the old gasket. The plug will be removed again to adjust the fluid level.
4.REMOVE FRONT DRIVE SHAFT ASSEMBLY
30400C
5.REMOVE CVT TYPE T OIL SEAL LH
Using SST, remove the CVT type T oil seal LH from the transaxle case.
Do not damage the transaxle case.
30400C
6.INSTALL CVT TYPE T OIL SEAL LH
Using SST and a hammer, tap in a new CVT type T oil seal LH to the transaxle case.
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Do not damage the lip of the CVT type T oil seal LH.
Coat the lip of the CVT type T oil seal LH with MP grease.
7.INSTALL FRONT DRIVE SHAFT ASSEMBLY
8.ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID
51444C
9.INSTALL REAR ENGINE UNDER COVER LH
51441
10.INSTALL NO. 1 ENGINE UNDER COVER