Home › Engine / Hybrid System › 2WW STARTING › STARTER › from 2015.10
RM3090E _51 Engine / Hybrid System _044379 2WW STARTING _0219541 STARTER A

2WW STARTING  STARTER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 12612A 3.REMOVE NO. 1 ENGINE COVER

Hide 51441 4.REMOVE NO. 1 ENGINE UNDER COVER

Hide 5.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

Hide 28899 7.REMOVE BATTERY INSULATOR

Hide 28800 8.REMOVE BATTERY

Hide 74431 9.REMOVE BATTERY TRAY

Hide 74414B 11.REMOVE BATTERY BRACKET REINFORCEMENT

Hide 25733A 12.DISCONNECT NO. 1 VACUUM PIPE

a.
A308565

Using an E7 "TORX" socket wrench, remove the bolt and disconnect the No. 1 vacuum pipe from the cylinder block sub-assembly.


b.

Remove the O-ring from the No. 1 vacuum pipe.


Hide 11409 13.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

a.
A308566

Disengage the 6 clamps and disconnect the No. 2 engine wire from the engine oil level dipstick guide.


b.

Remove the engine oil level dipstick.


c.
A313582

Disengage the clamp and disconnect the fuel feed pipe sub-assembly from the engine oil level dipstick guide.


d.

Using a T25 "TORX" socket wrench, remove the bolt and engine oil level dipstick guide.


e.

Remove the O-ring from the engine oil level dipstick guide.


Hide 28100 14.REMOVE STARTER ASSEMBLY

a.
A308563

Open the terminal cap.


b.

Remove the nut and disconnect the No. 2 engine wire from the starter assembly.


c.

Remove the nut and disconnect the engine wire from the starter assembly.


d.
A308564

Using an E14 "TORX" socket wrench, remove the 2 bolts and starter assembly.