Home › Engine / Hybrid System › 3ZR-FAE STARTING › STARTER(w/ Stop And Start System) › from 2015.10
RM3090E _51 Engine / Hybrid System _008393 3ZR-FAE STARTING _0166447 STARTER(w/ Stop And Start System) A

3ZR-FAE STARTING  STARTER(w/ Stop And Start System)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

Hide 51441 4.REMOVE NO. 1 ENGINE UNDER COVER

Hide 11212 5.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 17705 6.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 74404A 7.REMOVE BATTERY CLAMP SUB-ASSEMBLY

a.
A296336

Remove the bolt and loosen the nut.


b.

Detach the hook of the battery clamp sub-assembly from the front battery bracket, and then remove the battery clamp sub-assembly.


Hide 28800 8.REMOVE BATTERY

Hide 74431 9.REMOVE BATTERY TRAY

Hide 16057 10.DISCONNECT RADIATOR HOSE SUB-ASSEMBLY

a.
A348829

Remove the 2 bolts and disconnect the radiator hose sub-assembly from the front battery bracket.


Hide 74417 11.REMOVE FRONT BATTERY BRACKET

a.
A348830

Remove the 4 bolts and front battery bracket.


Hide 74414B 12.REMOVE BATTERY BRACKET REINFORCEMENT

a.
A348831

Remove the 2 bolts and battery bracket reinforcement.


Hide 33820B 13.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 33823 14.REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

Hide 28100 15.REMOVE STARTER ASSEMBLY

a.

Disconnect the terminal cap.


b.
A356582C01
0.104,0.135 0.344,0.313 0.24,0.177 10 false *A 0.104,2.521 0.365,2.75 0.26,0.229 10 true *B
*A for CVT
*B for Manual Transaxle


Remove the nut and disconnect the starter wire.


c.

Disconnect the starter connector.


d.

Remove the 2 bolts and starter assembly.


Hide 11363A 16.REMOVE FLYWHEEL HOUSING SIDE COVER

a.
A207285

Remove the flywheel housing side cover from the cylinder block.