52119A
1.REMOVE FRONT BUMPER COVER
16681
2.REMOVE UPPER RADIATOR AIR GUIDE PLATE
3.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
53388D
4.REMOVE HOOD TO FRONT FENDER SEAL RH
Remove the clip.
Detach the 3 clips and remove the hood to front fender seal RH.
53389B
5.REMOVE HOOD TO FRONT FENDER SEAL LH
Use the same procedure described for the RH side.
55701J
6.REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY
67913B
7.REMOVE FRONT DOOR SCUFF PLATE RH
62111C
8.REMOVE COWL SIDE TRIM BOARD RH
55545
9.REMOVE FUSE BOX OPENING COVER
53601
10.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Detach the 3 claws.
Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.
53629
11.REMOVE HOOD LOCK CONTROL CABLE COVER (w/ Cover)
Detach the clip and guide, and remove the hood lock control cable cover.
53510
12.REMOVE HOOD LOCK ASSEMBLY
| *A | w/ Engine Hood Courtesy Switch |
| *B | w/o Engine Hood Courtesy Switch |
w/ Engine Hood Courtesy Switch:
Disconnect the connector.
Remove the 3 bolts.
| *A | w/ Engine Hood Courtesy Switch |
| *B | w/o Engine Hood Courtesy Switch |
Disconnect the hood lock control cable assembly and remove the hood lock assembly.
53630
13.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY
| *1 | String |
Tie a string to the end of the hood lock control cable assembly as shown in the illustration.
Use a length of string long enough to pass through the engine compartment.
Detach each clamp, and then pull out the hood lock control cable assembly from the vehicle body.
Untie the string from the hood lock control cable assembly.
| *1 | Hood Lock Control Cable | *2 | Stopper |