Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER
RM3620E _56 Audio / Visual / Telematics _076047 AUDIO / VIDEO _0370114 NOISE FILTER A

AUDIO / VIDEO  NOISE FILTER  REMOVAL  


PROCEDURE

Hide 64910N 1.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 58410B 2.REMOVE DECK BOARD ASSEMBLY

Hide 58417H 3.REMOVE REAR NO. 3 FLOOR BOARD

Hide 64993 4.REMOVE REAR DECK FLOOR BOX (w/o Spare Tire)

Hide 5.REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY

Hide 72693 6.REMOVE REAR SEAT CUSHION LOCK HOOK

Hide 67918E 7.REMOVE REAR DOOR SCUFF PLATE LH

Hide 58386 8.REMOVE REAR FLOOR FINISH PLATE

Hide 9.REMOVE REAR SEATBACK ASSEMBLY LH

Hide 58467H 10.REMOVE NO. 3 BATTERY SERVICE COVER BOARD (for HV Model)

Hide 71304C 11.REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH

Hide 73706 12.REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH

Hide 58577E 13.REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE

Hide 62332C 14.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

HINT:

Pull back the rear door opening trim weatherstrip LH so that the rear seat side garnish LH and inner roof side garnish assembly LH can be removed.

Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR OPENING TRIM WEATHERSTRIP>REMOVAL


Hide 62552F 15.REMOVE REAR SEAT SIDE GARNISH LH

Hide 73708A 16.REMOVE TETHER ANCHOR BRACKET SET

Hide 58460D 17.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY

Hide 64740E 18.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 62480A 19.REMOVE INNER ROOF SIDE GARNISH ASSEMBLY LH

Hide 86011V 20.REMOVE RADIO SETTING CONDENSER

NOTICE:

When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


a.
E406831

Remove the bolt.


b.

Detach the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.


c.
E365957C03
0,0 0,0 false
V113147

Remove in this Direction


Using a screwdriver, detach the claw and remove the terminal cover with wire harness from the condenser as shown in the illustration.


d.
E227453

Using a screwdriver, bend back and break off the claw as shown in the illustration.


e.

Remove the terminal cover from the wire harness.

NOTICE:
·

Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

·

Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

·

Check for deformation of the terminal after the wire harness has been removed from the terminal cover.