Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for HV Model) › 2018.10–2019.02
RM3620E _58 Vehicle Interior _076130 HEATING / AIR CONDITIONING _0370842 AIR CONDITIONING SYSTEM(for HV Model) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for HV Model)  B1449  Air Outlet Damper Control Servo Motor Circuit (Rear)  


DESCRIPTION

The No. 2 air conditioning radiator damper servo sub-assembly (rear mode) sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the air outlet damper to the appropriate position, which controls the rear air outlet switching. The air conditioning amplifier assembly communicates with the servo through a communication/driver IC and wiring assembly called the air conditioning harness assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory
B1449 Air Outlet Damper Control Servo Motor Circuit (Rear)
·

Diagnosis condition: During No. 2 air conditioning radiator damper servo sub-assembly (rear mode) operation

·

Malfunction status: The damper servo operation request signal is output but the position information of the servo does not change or servo is malfunctioning

·

Detection time: Continuously for 30 seconds or more


·

No. 2 air conditioning radiator damper servo sub-assembly (rear mode)

·

Air conditioning harness assembly

·

Air conditioning amplifier assembly


Memorized
(30 sec. or more)*

*: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.


DTC Detection Condition Combination Table
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition No. 2 air conditioning radiator damper servo sub-assembly (rear mode) operating ○ ○
Malfunction Air outlet damper servo operation request signals are output but the rear passenger side air outlet damper position sensor value does not change ○ -
Air outlet damper servo operation request signals are output but the rear passenger side air outlet damper position sensor value is abnormal - ○
Detection Time Continuously for 30 seconds or more Continuously for 30 seconds or more
Trip Count 1 trip 1 trip

HINT:

If the conditions of either of these patterns are detected, a DTC will be stored


WIRING DIAGRAM

E315725E43
5.198,0.75 5.969,0.948 0.771,0.198 10 false BUS 5.219,1.135 5.99,1.333 0.771,0.198 10 false B BUS 5.219,1.531 5.99,1.729 0.771,0.198 10 false BUS G 4.99,0.698 5.26,0.896 0.271,0.198 10 false 3 5,1.135 5.271,1.333 0.271,0.198 10 false 4 5,1.531 5.271,1.729 0.271,0.198 10 false 2 3.25,2.073 4.802,2.531 1.552,0.458 10 false Air Conditioning Harness Assembly 5.188,2.323 6.021,2.521 0.833,0.198 10 false z11 5.188,2.479 6.75,2.969 1.563,0.49 10 false Air Conditioning Amplifier Assembly 0.771,2.219 2.667,2.74 1.896,0.521 10 false No. 2 Air Conditioning Radiator Damper Servo Sub-assembly 6.021,0.865 6.406,1.063 0.385,0.198 10 false IC 0.667,3.344 2.927,3.615 2.26,0.271 10 false : LIN Communication Line 1.198,1.25 2.177,1.469 0.979,0.219 10 false Rear Mode 6.521,1.125 6.906,1.323 0.385,0.198 10 false +B

CAUTION / NOTICE / HINT

HINT:
·

Confirm that no mechanical problems are present because this DTC can be stored when either a damper link or damper is mechanically locked.

·

When installing a servo motor, make sure to install it correctly.

·

When the servo motor is replaced, be sure to perform servo motor initialization.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for HV Model)>INITIALIZATION



PROCEDURE

1.CHECK FOR DTC
a.

Check for DTCs.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for HV Model)>DTC CHECK / CLEAR

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
B1449 is output A
B1449 and B1497 are output B



A

2.INSPECT NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (INSTALLATION CONDITION)

B

2.INSPECT NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (INSTALLATION CONDITION)
a.

Check that the No. 2 air conditioning radiator damper servo sub-assembly is installed correctly.

OK:

The No. 2 air conditioning radiator damper servo sub-assembly is installed correctly.



Result:
Proceed to
OK
NG



OK

3.INSPECT NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (MOTOR, LINK, DAMPER)

NG

INSTALL NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY CORRECTLY

3.INSPECT NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (MOTOR, LINK, DAMPER)
a.

Check for a wire harness caught between the links of the motors and dampers.

OK:

No wire harnesses are caught between the links of the motors and dampers.



Result:
Proceed to
OK
NG



OK

4.INSPECT AIR CONDITIONING RADIATOR ASSEMBLY (DAMPER)

NG

REMOVE PINCHED WIRE HARNESS

4.INSPECT AIR CONDITIONING RADIATOR ASSEMBLY (DAMPER)
a.

Remove the No. 2 air conditioning radiator damper servo sub-assembly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT (for A25A-FXS)>DISASSEMBLY


b.

Operate the dampers by hand.

OK:

The dampers are easily operated by hand.



Result:
Proceed to
OK
NG



OK

5.CHECK NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

NG

REPAIR OR REPLACE AIR CONDITIONING RADIATOR ASSEMBLY

5.CHECK NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
a.

Interchange the No. 2 air conditioning radiator damper servo sub-assembly (rear mode) with the No. 1 air conditioning radiator damper servo sub-assembly (front passenger side air mix) and connect the connectors to them.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT (for A25A-FXS)>DISASSEMBLY


b.

Clear the DTCs.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for HV Model)>DTC CHECK / CLEAR

Body Electrical > Air Conditioner > Clear DTCs
50002 121

c.

Check for DTCs.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for HV Model)>DTC CHECK / CLEAR

Body Electrical > Air Conditioner > Trouble Codes
50001 121
Result:
Result Proceed to
DTC B1441 is output A
DTC B1449 is output B
DTC B1441 and B1449 are not output C


HINT:

Codes other than DTC B1441 and B1449 may be output at this time, but they are not related to this check.




A

REPLACE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

B

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

C