The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery state sensor assembly removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
28850C
2.REMOVE BATTERY STATE SENSOR ASSEMBLY
Remove the nut to disconnect the engine wire from the battery state sensor assembly.
Loosen the nut and disconnect the battery state sensor assembly from the battery.
Disconnect the battery state sensor assembly connector.
Detach the clamp and disconnect the engine wire from the battery state sensor assembly.
Detach the 2 claws and remove the battery state sensor assembly from the battery current sensor holder.