The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during input shaft type T oil seal removal/installation are shown below.
Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
| *a | An Object Exceeding Weight Limit of Engine Lifter |
The engine assembly with transaxle is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly with transaxle may fall off the engine lifter.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
If the ECM has been struck or dropped, replace it.
Perform Vehicle Identification Number (VIN) registration when replacing the ECM.
w/ Canister Pump Module:
Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>REGISTRATION
w/o Canister Pump Module:
Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>REGISTRATION
30900
1.REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY
35710A
2.REMOVE INPUT SHAFT TYPE T OIL SEAL
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the input shaft type T oil seal from the hybrid vehicle transaxle assembly.
Be careful not to damage the input shaft assembly or hybrid vehicle transaxle assembly.
35710A
3.INSTALL INPUT SHAFT TYPE T OIL SEAL
Coat the lip of a new input shaft type T oil seal with a small amount of MP grease.
| *a | Depth |
Using SST and a hammer, install the input shaft type T oil seal to the hybrid vehicle transaxle assembly.
1.9 to 2.7 mm (0.0748 to 0.106 in.)
Do not allow foreign matter to attach to the lip of the input shaft type T oil seal.
Do not install the input shaft type T oil seal at an angle.
30900
4.INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY