The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during cylinder head removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
13711
1.REMOVE INTAKE VALVE
Using SST, compress each intake valve compression spring and remove the 8 valve spring retainer locks.
Arrange the removed parts in such a way that they can be reinstalled to their original locations.
Remove the 8 valve spring retainers, 8 intake valve compression springs and 8 intake valves from the cylinder head sub-assembly.
Arrange the removed parts in such a way that they can be reinstalled to their original locations.
13715
2.REMOVE EXHAUST VALVE
Using SST, compress each exhaust valve compression spring and remove the 8 valve spring retainer locks.
Arrange the removed parts in such a way that they can be reinstalled to their original locations.
Remove the 8 valve spring retainers, 8 exhaust valve compression springs and 8 exhaust valves from the cylinder head sub-assembly.
Arrange the removed parts in such a way that they can be reinstalled to their original locations.
3.REMOVE VALVE STEM OIL SEAL
Using needle-nose pliers, remove the 16 valve stem oil seals.
13734A
4.REMOVE INTAKE VALVE SPRING SEAT
Using compressed air and a Magnet Hand, remove the 8 intake valve spring seats from the cylinder head sub-assembly by blowing air onto them.
13734B
5.REMOVE EXHAUST VALVE SPRING SEAT
Using compressed air and a Magnet Hand, remove the 8 exhaust valve spring seats from the cylinder head sub-assembly by blowing air onto them.
11117E
6.REMOVE NO. 1 STRAIGHT SCREW PLUG
If coolant leaks from a No. 1 straight screw plug or a plug is corroded, replace it.
Using a 6 mm straight hexagon wrench, remove the 4 No. 1 straight screw plugs from the cylinder head sub-assembly.
7.REMOVE STUD BOLT
If a stud bolt is deformed or its threads are damaged, replace it.
Using an E8 "TORX" socket wrench, remove the 7 stud bolts.