Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
48720A
1.TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY
Temporarily install the rear No. 1 suspension arm assembly to the rear axle carrier sub-assembly and rear suspension member sub-assembly with the 2 bolts and 2 nuts.
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
Insert the bolt with the threaded end facing the rear of the vehicle.
48740F
2.TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY
Temporarily install the rear No. 2 suspension arm assembly to the rear suspension member sub-assembly with the No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and nut.
Insert the rear suspension toe adjust cam sub-assembly from the front of the vehicle.
When tightening the nut, keep the rear suspension toe adjust cam sub-assembly from rotating.
48258C
3.INSTALL REAR LOWER COIL SPRING INSULATOR
48231B
4.INSTALL REAR COIL SPRING
5.STABILIZE SUSPENSION
48840A
6.INSTALL REAR STABILIZER LINK ASSEMBLY
48720A
7.INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY
Install the rear No. 1 suspension arm assembly with the 2 bolts.
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
48740F
8.INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY
Install the rear No. 2 suspension arm assembly (rear axle carrier sub-assembly side) with the bolt.
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
48738C
9.INSTALL LOWER NO. 2 CONTROL ARM COVER (w/ Cover)
Engage the 2 claws and guide to install the lower No. 2 control arm cover to the rear No. 2 suspension arm assembly.
Install the clip.
Install the bolt.
89408C
10.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (for LH Side)
11.INSTALL REAR WHEEL
48740F
12.INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY
Lower the vehicle to the ground.
Bounce the vehicle up and down at the corners to stabilize the rear suspension.
| *a | Matchmark |
Align the matchmarks on the No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and rear suspension member sub-assembly.
Fully tighten the nut.
Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.
Make sure that the vehicle is unloaded when fully tightening the nut.
13.INSPECT AND ADJUST REAR WHEEL ALIGNMENT
14.PERFORM INITIALIZATION
| Parking Support Brake System (for HV model) | ( )
|
| Parking Assist Monitor System | ( )
|
| Panoramic View Monitor System (for HV model) | ( )
|
| Lighting System (EXT) | ( )
|
| Parking Support Brake System (for Gasoline model) | ( )
|
| Parking Assist Monitor System | ( )
|
| Panoramic View Monitor System (for Gasoline model) | ( )
|
| Lighting System (EXT) | ( )
|