The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
w/ Stop And Start System:
When replacing the battery, use a new battery of the same dimensions with a capacity of 65 Ah or more at a 20-hour rate.
w/o Stop And Start System:
When replacing the battery, use a new battery of the same dimensions with a capacity of 60 Ah or more at a 20-hour rate.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
| *A | w/o Stop And Start System |
| *B | w/ Stop And Start System |
Loosen the nut, and disconnect the cable from the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
28800
3.REMOVE BATTERY
| *a | Side View of Claws |
|
Push Battery Terminal Cap Here |
|
Push |
Detach the 2 claws as shown in the illustration and remove the connector cover from the positive (+) battery terminal.
Loosen the nut and disconnect the cable from the positive (+) battery terminal.
|
Remove in this Direction |
Remove the bolt and No. 2 battery clamp from the battery clamp sub-assembly.
Remove the battery from the vehicle.