Home › General › MAINTENANCE › A25A-FKS BATTERY › 2018.10–2020.08
RM3620E _V1 General _076298 MAINTENANCE _0372245 A25A-FKS BATTERY A

MAINTENANCE  A25A-FKS BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for Gasoline model) (Click here)
Reset back door close position Power back door system (for Gasoline model) (Click here)
Power back door initialization Power door lock control system (Click here)

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

w/ Stop And Start System:

When replacing the battery, use a new battery of the same dimensions with a capacity of 65 Ah or more at a 20-hour rate.

·

w/o Stop And Start System:

When replacing the battery, use a new battery of the same dimensions with a capacity of 60 Ah or more at a 20-hour rate.



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

a.
A432025C02
0,0 0.26,0.229 0.26,0.229 12 true *A 0,2.469 0.271,2.677 0.271,0.208 12 true *B
*A w/o Stop And Start System
*B w/ Stop And Start System


Loosen the nut, and disconnect the cable from the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 28800 3.REMOVE BATTERY

a.
A432026C02
0.563,0.188 0.875,0.344 0.313,0.156 10 false *a
*a Side View of Claws
V113146

Push Battery Terminal Cap Here
V113147

Push


Detach the 2 claws as shown in the illustration and remove the connector cover from the positive (+) battery terminal.


b.
A432027

Loosen the nut and disconnect the cable from the positive (+) battery terminal.


c.
A432028

Remove the bolt and No. 2 battery clamp from the battery clamp sub-assembly.


d.

Remove the battery from the vehicle.