Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SYSTEM
RM3620E _59 Vehicle Exterior _076527 WINDOW / GLASS _0372339 WINDOW DEFOGGER SYSTEM J

WINDOW / GLASS  WINDOW DEFOGGER SYSTEM  Rear Window Defogger System does not Operate  


DESCRIPTION

When the window defogger switch on the air conditioning control assembly is pressed, the operation signal is transmitted to the air conditioning amplifier assembly via LIN communication. When the air conditioning amplifier assembly receives the signal, it turns on the defogger relay (DEF) to operate the window defogger system.

WIRING DIAGRAM

E403042E01
2.615,5.333 2.771,5.531 0.156,0.198 10 false L 3.573,5.313 3.729,5.51 0.156,0.198 10 false B 2.354,0.708 2.719,0.896 0.365,0.188 10 false LIN1 5.792,0.677 6.156,0.865 0.365,0.188 10 false LIN1 3.563,1.958 3.813,2.125 0.25,0.167 10 false 2 4.479,2.458 4.729,2.625 0.25,0.167 10 false 3 3.875,2.969 4.125,3.135 0.25,0.167 10 false 4 3.573,2.458 3.823,2.625 0.25,0.167 10 false 5 4.49,1.958 4.74,2.125 0.25,0.167 10 false 1 2.302,5.219 2.552,5.385 0.25,0.167 10 false 1 3.906,5.219 4.156,5.385 0.25,0.167 10 false 1 5.771,2.063 6.208,2.25 0.438,0.188 10 false RDFG 4.281,3.01 5.25,3.385 0.969,0.375 10 false Defogger Relay (DEF) 0.333,2.052 1.646,2.271 1.313,0.219 10 false from IG1 NO.1 Relay 0.271,2.552 1.688,2.771 1.417,0.219 10 false from Auxiliary Battery 2.229,5.417 2.542,5.615 0.313,0.198 10 false R22 3.875,5.417 4.188,5.615 0.313,0.198 10 false R2 2.219,2.219 3.177,2.417 0.958,0.198 10 false ECU-IG1 NO.3 2.521,2.76 2.927,2.948 0.406,0.188 10 false DEF 1.24,1.188 3.333,1.573 2.094,0.385 10 false Air Conditioning Control Assembly (Window Defogger Switch) 2.177,5.927 4.281,6.198 2.104,0.271 10 false Back Door Glass (Defogger Wire) 5.635,2.844 6.677,3.448 1.042,0.604 10 false Air Conditioning Amplifier Assembly 0.698,6.458 2.396,6.698 1.698,0.24 10 false : LIN Communication Line 4.01,3.823 4.167,4.021 0.156,0.198 10 false 1 2.635,4.271 2.948,4.469 0.313,0.198 10 false N2 2.615,4.458 4.177,4.823 1.563,0.365 10 false Radio Setting Condenser (Noise Filter) 5.615,2.677 6.073,2.875 0.458,0.198 10 false G47 5.479,1.927 5.792,2.125 0.313,0.198 10 false 18 3.563,3.823 4.177,4.021 0.615,0.198 10 false DEF+

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following procedure.

·

If the auxiliary battery voltage becomes low, window defogger system operation is canceled to prioritize supplying power to the power steering system.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST



PROCEDURE

1.CHECK AIR CONDITIONING SYSTEM
a.

Check the air conditioning system.


HINT:

Both the window defogger system operation signal and air conditioning system operation signal are transmitted to the air conditioning amplifier assembly via the same communication line.


OK:

The air conditioning system operates normally.



Result:
Result Proceed to
OK A
NG (for HV Model) B
NG (for Gasoline Model) C



A

2.CHECK AIR CONDITIONING CONTROL ASSEMBLY

B

C

2.CHECK AIR CONDITIONING CONTROL ASSEMBLY
a.

Check that the defogger indicator illuminates when the defogger switch is on.

OK:

Defogger indicator illuminates.



Result:
Proceed to
OK
NG



OK

3.PERFORM ACTIVE TEST USING GTS

NG

REPLACE AIR CONDITIONING CONTROL ASSEMBLY

3.PERFORM ACTIVE TEST USING GTS
a.

Using the GTS, perform the Active Test.

Click hereVehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>DATA LIST / ACTIVE TEST

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Defogger Relay (Rear) Defogger relay (DEF) OFF or ON -
Body Electrical > Air Conditioner > Active Test
Tester Display
Defogger Relay (Rear)
50004 121 22
OK:

Back door glass (defogger wire) warms up.



Result:
Proceed to
OK
NG



OK

4.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

5.CHECK HARNESS AND CONNECTOR (BACK DOOR GLASS [DEFOGGER WIRE] - BATTERY)
4.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
a.

Replace the air conditioning amplifier assembly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER>REMOVAL


b.

Check that the window defogger system operates normally.

OK:

The window defogger system operates normally.



Result:
Proceed to
OK
NG



OK

END (AIR CONDITIONING AMPLIFIER ASSEMBLY IS DEFECTIVE)

NG

REPLACE AIR CONDITIONING CONTROL ASSEMBLY

5.CHECK HARNESS AND CONNECTOR (BACK DOOR GLASS [DEFOGGER WIRE] - BATTERY)
a.
E403076C03
1.448,0.208 1.833,0.438 0.385,0.229 0.552,0.844 0.781,0.844 0.781,0.844 1.479,1.427 true 0.104,0.083 0.417,0.281 0.313,0.198 10 false *a 1.563,0.24 1.875,0.438 0.313,0.198 10 false R2 0.385,0.75 0.542,0.948 0.156,0.198 10 false B
*a Front view of wire harness connector
(to Back Door Glass [Defogger Wire])


Disconnect the back door glass (defogger wire) connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
R2-1 (B) - Body ground Ignition switch ON, window defogger switch on 11 to 14 V
Ignition switch ON, window defogger switch off Below 1 V



Result:
Proceed to
OK
NG



OK

6.CHECK HARNESS AND CONNECTOR (BACK DOOR GLASS [DEFOGGER WIRE] - BODY GROUND)

NG

7.INSPECT DEFOGGER RELAY (DEF)
6.CHECK HARNESS AND CONNECTOR (BACK DOOR GLASS [DEFOGGER WIRE] - BODY GROUND)
a.
E403076C04
1.458,0.188 1.844,0.427 0.385,0.24 1.479,1.448 0.865,0.854 0.865,0.854 0.594,0.854 true 0.104,0.104 0.417,0.302 0.313,0.198 10 false *a 1.531,0.219 1.844,0.417 0.313,0.198 10 false R22 0.438,0.771 0.594,0.969 0.156,0.198 10 false L
*a Front view of wire harness connector
(to Back Door Glass [Defogger Wire])


Disconnect the back door glass (defogger wire) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R22-1 (L) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPAIR BACK DOOR GLASS (DEFOGGER WIRE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.INSPECT DEFOGGER RELAY (DEF)
a.

Remove the defogger relay (DEF) from the No. 1 engine room relay block.


b.

Inspect the defogger relay (DEF).

Click hereVehicle Exterior>WINDOW / GLASS>RELAY>ON-VEHICLE INSPECTION


Result:
Proceed to
OK
NG



OK

8.CHECK HARNESS AND CONNECTOR (DEFOGGER RELAY [DEF] - BATTERY)

NG

REPLACE DEFOGGER RELAY (DEF)

8.CHECK HARNESS AND CONNECTOR (DEFOGGER RELAY [DEF] - BATTERY)
a.
E403043C01
0.104,0.094 0.417,0.292 0.313,0.198 10 false *a
*a Front view of wire harness connector
(to Defogger Relay [DEF])


Remove the defogger relay (DEF) from the No. 1 engine room relay block.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
Defogger relay (DEF) terminal 2 - Body ground Ignition switch ON 11 to 14 V
Defogger relay (DEF) terminal 5 - Body ground Ignition switch off 11 to 14 V



Result:
Proceed to
OK
NG



OK

9.CHECK HARNESS AND CONNECTOR (DEFOGGER RELAY [DEF] - AIR CONDITIONING AMPLIFIER ASSEMBLY AND BACK DOOR GLASS [DEFOGGER WIRE])

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

9.CHECK HARNESS AND CONNECTOR (DEFOGGER RELAY [DEF] - AIR CONDITIONING AMPLIFIER ASSEMBLY AND BACK DOOR GLASS [DEFOGGER WIRE])
a.

Remove the defogger relay (DEF) from the No. 1 engine room relay block.


b.

Disconnect the G47 air conditioning amplifier assembly connector.


c.

Disconnect the N2 radio setting condenser (noise filter) connector.


d.

Disconnect the R2 back door glass (defogger wire) connector.


e.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Defogger relay (DEF) terminal 1 - G47-18 (RDFG) Always Below 1 Ω
Defogger relay (DEF) terminal 3 - R2-1 (B) Always Below 1 Ω
Defogger relay (DEF) terminal 1 or G47-18 (RDFG) - Body ground Always 10 kΩ or higher
Defogger relay (DEF) terminal 3 or R2-1 (B) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR