Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER MOTOR
RM3620E _59 Vehicle Exterior _076564 WIPER / WASHER _0373161 HEADLIGHT CLEANER MOTOR A

WIPER / WASHER  HEADLIGHT CLEANER MOTOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the headlight cleaner motor and pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly (Including removal and installation)
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking support brake system (for HV model) (Click here)
Front television camera view adjustment Panoramic view monitor system (for HV model) (Click here)

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly (Including removal and installation)
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking support brake system (for Gasoline model) (Click here)
Front television camera view adjustment Panoramic view monitor system (for Gasoline model) (Click here)

PROCEDURE

Hide 85280A 3.REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY

a.
B530388C01
0,0 0,0 false
V113147

Remove in this Direction


Loosen the clip and remove the headlight cleaner hose as shown in the illustration.


b.
B530389C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the connector.


c.

Remove the headlight cleaner motor and pump assembly as shown in the illustration.