The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during port fuel injector assembly removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) auxiliary battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
To prevent serious injury due to fuel spray from the high-pressure fuel lines, always discharge fuel system pressure before removing any fuel system components.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. DISCHARGE FUEL SYSTEM PRESSURE
58410B
3.REMOVE DECK BOARD ASSEMBLY
58416K
4.REMOVE REAR NO. 2 FLOOR BOARD
65351A
5.REMOVE BATTERY HOLE COVER
6.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
22030
7.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
25620
8.REMOVE EGR VALVE ASSEMBLY
16278
9.REMOVE NO. 2 WATER BY-PASS PIPE
23901
10.DISCONNECT FUEL TUBE SUB-ASSEMBLY
Remove the fuel pipe clamp from the fuel tube connector.
Disconnect the fuel tube sub-assembly from the fuel delivery pipe sub-assembly.
Click hereEngine / Hybrid System>A25A-FXS (FUEL)>FUEL SYSTEM>PRECAUTION
23801P
11.REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY
23807
12.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY
Disconnect the connector from the No. 5 engine wire.
Remove the 2 bolts and fuel delivery pipe sub-assembly from the cylinder head sub-assembly.
Be careful not to drop the port fuel injector assemblies when removing the fuel delivery pipe sub-assembly.
23807V
13.REMOVE NO. 1 DELIVERY PIPE SPACER
Remove the 2 No. 1 delivery pipe spacers from the cylinder head sub-assembly.
23291
14.REMOVE INJECTOR VIBRATION INSULATOR
Remove the 4 injector vibration insulators from the cylinder head sub-assembly.
82125N
15.REMOVE NO. 5 ENGINE WIRE
Disconnect the 5 connectors from the 4 port fuel injector assemblies and fuel pressure sensor.
Detach the 2 clamps and remove the No. 5 engine wire from the fuel delivery pipe sub-assembly.
23250F
16.REMOVE PORT FUEL INJECTOR ASSEMBLY
Pull the 4 port fuel injector assemblies out of the fuel delivery pipe sub-assembly.
Remove the O-ring from each port fuel injector assembly.
Attach a tag or label with the corresponding cylinder number to each port fuel injector assembly so that they can be installed to their original locations.
Cover the port fuel injector assemblies with plastic bags to prevent damage and contamination.