This DTC is stored when a malfunction occurs in the parking assist monitor system*1 or panoramic view monitor system*2.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1610 | Camera ECU Malfunction | ·
Malfunction occurs in the parking assist monitor system*1 ·
Malfunction occurs in the panoramic view monitor system*2 |
·
Parking assist monitor system*1 ·
Panoramic view monitor system*2 ·
Radio and display receiver assembly |
*1: w/ Parking Assist Monitor System
*2: w/ Panoramic View Monitor System
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio and display receiver assembly may not operate normally.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| w/ Parking Assist Monitor System | A |
| w/ Panoramic View Monitor System | B |
A
B
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check that no DTCs are output.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Clear the DTCs.
for HV Model: Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM(for HV Model)>HOW TO PROCEED WITH TROUBLESHOOTING
for Gasoline Model: Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM(for Gasoline Model)>HOW TO PROCEED WITH TROUBLESHOOTING
Recheck for DTCs and check that no DTCs are output.
for HV Model: Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM(for HV Model)>HOW TO PROCEED WITH TROUBLESHOOTING
for Gasoline Model: Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM(for Gasoline Model)>HOW TO PROCEED WITH TROUBLESHOOTING
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG