Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU
RM3620E _58 Vehicle Interior _076036 SUPPLEMENTAL RESTRAINT SYSTEMS _0374458 OCCUPANT CLASSIFICATION ECU A

SUPPLEMENTAL RESTRAINT SYSTEMS  OCCUPANT CLASSIFICATION ECU  INSTALLATION  


PROCEDURE

Hide 89952 1.INSTALL OCCUPANT DETECTION ECU

a.
B523184

Attach the claw to install the occupant detection ECU.

NOTICE:
·

If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.

·

When installing the occupant detection ECU, make sure that the SRS wiring does not interfere with or is pinched between other parts.




b.
B523182

Connect the 2 connectors.


Hide 2.INSTALL FRONT SEAT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>INSTALLATION


Hide 3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 65351A 4.INSTALL BATTERY HOLE COVER (for HV Model)

Hide 58416K 5.INSTALL REAR NO. 2 FLOOR BOARD (for HV Model)

Hide 58410B 6.INSTALL DECK BOARD ASSEMBLY (for HV Model)