Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for Triple Beam Headlight)
RM3620E _59 Vehicle Exterior _077130 LIGHTING (EXT) _0375585 HEADLIGHT ASSEMBLY(for Triple Beam Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for Triple Beam Headlight)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the headlight ECU sub-assembly LH removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Headlight ECU sub-assembly LH
·

Synchronize the vehicle information

·

Initialization of the headlight ECU sub-assembly LH


Automatic headlight beam level control system (Click here)
Front bumper assembly (Including removal and installation)
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking support brake system (for Gasoline model) (Click here)
Front television camera view adjustment Panoramic view monitor system (for Gasoline model) (Click here)

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Headlight ECU sub-assembly LH
·

Synchronize the vehicle information

·

Initialization of the headlight ECU sub-assembly LH


Automatic headlight beam level control system (Click here)
Front bumper assembly (Including removal and installation)
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


Parking support brake system (for HV model) (Click here)
Front television camera view adjustment Panoramic view monitor system (for HV model) (Click here)

NOTICE:

Even if the headlight ECU sub-assembly RH is replaced with a new one, synchronize the vehicle information and initialization are not necessary.


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 2.REMOVE HEADLIGHT ASSEMBLY LH

a.
E403978C01
0,0 0,0 false
V100135

Screw
V100136

Bolt
V100155

Protective Tape


Apply protective tape as shown in the illustration.


b.

Remove the 3 screws and bolt.


c.
E403974C01
1.542,4.271 1.219,4.01 true 1.573,4.188 1.885,4.344 0.313,0.156 10 false *b 0.302,0.271 0.49,0.427 0.188,0.156 10 true *a
*a Lower Bracket
*b Connector Lock Lever
V113146

Place Hands Here
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Place your hand on 2 brackets of the headlight assembly LH to disconnect them from the screw seats.

NOTICE:

Be careful not to break the bracket.



d.

Slide the headlight assembly LH in the direction indicated by the arrow (1) and detach the guide and lower bracket.


e.

Slide the headlight assembly LH in the direction indicated by the arrow (2) to remove it.


f.

Release the connector lock lever and disconnect the connector under the headlight assembly LH.