Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER
RM3620E _58 Vehicle Interior _076046 DOOR LOCK _0377382 DOOR CONTROL RECEIVER A

DOOR LOCK  DOOR CONTROL RECEIVER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the door control and tire pressure monitoring system receiver assembly or electrical key and tire pressure monitoring system receiver assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
w/ Tire Pressure Warning System:

Tire pressure warning ECU and receiver


·

Register transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates

·

Tire pressure warning function


for Initialization(Click here)
for Registration(Click here)

Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
w/ Tire Pressure Warning System:

Tire pressure warning ECU and receiver


·

Register transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates

·

Tire pressure warning function


for Initialization(Click here)
for Registration(Click here)
w/o Entry and Start System:

Door control receiver


Register a new recognition code Wireless door lock control system (w/o Smart Entry and Start System) (Click here)

PROCEDURE

Hide 1.REMOVE REAR SEAT ASSEMBLY

Hide 73705 2.REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.

Click hereVehicle Interior>SEAT BELT>CHILD RESTRAINT SEAT ANCHOR BRACKET>REMOVAL


Hide 64910N 3.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 58410B 4.REMOVE DECK BOARD ASSEMBLY

Hide 58416K 5.REMOVE REAR NO. 2 FLOOR BOARD

Hide 64993 6.REMOVE REAR DECK FLOOR BOX (w/o Spare Tire)

Hide 58386 7.REMOVE REAR FLOOR FINISH PLATE

Hide 58577E 8.REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE

Hide 67917C 9.REMOVE REAR DOOR SCUFF PLATE RH (for Gasoline Model)

HINT:

Use the same procedure described for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 62331C 10.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
·

Pull back the rear seat side garnish RH so that the rear door opening trim weatherstrip RH can be removed.

·

Use the same procedure described for the LH side.

Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR OPENING TRIM WEATHERSTRIP>REMOVAL



Hide 62551F 11.REMOVE REAR SEAT SIDE GARNISH RH

HINT:

Use the same procedure described for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 73708A 12.REMOVE TETHER ANCHOR BRACKET SET

Hide 58460D 13.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY

Hide 64740E 14.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 62470A 15.REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 89741 16.REMOVE DOOR CONTROL RECEIVER (w/o Tire Pressure Warning System, w/ Smart Key System)

a.
B526427C01
0,0 0,0 false
V100135

Bolt
V100136

Connector


Remove the bolt.


b.

Detach the guide and remove the door control receiver.


c.

Disconnect the connector.

NOTICE:
·

Do not subject the door control receiver to strong impacts or force, and do not drop it.

·

Do not reuse the door control receiver that has been dropped.




Hide 89741 17.REMOVE DOOR CONTROL RECEIVER (w/o Tire Pressure Warning System, w/o Smart Key System)

HINT:

Use the same procedure described for the door control receiver.


Hide 897A0 18.REMOVE DOOR CONTROL AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY (w/ Tire Pressure Warning System, w/o Smart Key System)

HINT:

Use the same procedure described for the door control receiver.


Hide 897B0 19.REMOVE ELECTRICAL KEY AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY (w/ Tire Pressure Warning System, w/ Smart Key System)

HINT:

Use the same procedure described for the door control receiver.