Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER
RM3620E _53 Suspension _076850 TIRE PRESSURE MONITORING _0377451 TIRE PRESSURE WARNING RECEIVER A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the tire pressure warning receiver removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model:)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Tire pressure warning ECU and receiver
·

Register transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

·

Tire pressure warning function


for Initialization:(Click here)
for Registration:(Click here)

Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model:)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Tire pressure warning ECU and receiver
·

Register transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

·

Tire pressure warning function


for Initialization:(Click here)
for Registration:(Click here)

PROCEDURE

Hide 1.REMOVE REAR SEAT ASSEMBLY

Hide 73705 2.REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.

Click hereVehicle Interior>SEAT BELT>CHILD RESTRAINT SEAT ANCHOR BRACKET>REMOVAL


Hide 64910N 3.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 58410B 4.REMOVE DECK BOARD ASSEMBLY

Hide 58416K 5.REMOVE REAR NO. 2 FLOOR BOARD

Hide 64993 6.REMOVE REAR DECK FLOOR BOX (w/o Spare Tire)

Hide 58386 7.REMOVE REAR FLOOR FINISH PLATE

Hide 58577E 8.REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE

Hide 67917C 9.REMOVE REAR DOOR SCUFF PLATE RH

HINT:

Use the same procedure described for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 62331C 10.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:
·

Pull back the No. 3 rear seat side garnish RH so that the rear door opening trim weatherstrip RH can be removed.

·

Use the same procedure described for the LH side.

Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR OPENING TRIM WEATHERSTRIP>REMOVAL



Hide 62551F 11.REMOVE REAR SEAT SIDE GARNISH RH

HINT:

Use the same procedure described for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 73708A 12.REMOVE TETHER ANCHOR BRACKET SET

Hide 58460D 13.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY

Hide 64740E 14.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH

Hide 62470A 15.REMOVE INNER ROOF SIDE GARNISH ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 89760C 16.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
·

Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.

·

If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



a.
C406965C01
0,0 0,0 false
V100135

Bolt
V100136

Connector


Remove the bolt.


b.

Detach the 2 guides and tire pressure warning ECU and receiver.


c.

Disconnect the connector.