The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat inner belt assembly removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
for HV Model with Occupant Classification System:
for Gasoline Model with Occupant Classification System:
w/o Occupant Classification System:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If an SRS part is accidentally deployed, it may cause a serious injury.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
2.REMOVE FRONT SEAT ASSEMBLY LH
73240
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)
w/o Occupant Classification System:
Detach the clamp and claw.
w/ Occupant Classification System:
Detach the clamp and claw.
Disconnect the connector.
Remove the nut and front seat inner belt assembly LH.
Remove the front seat belt anchor plate.
73230
4.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)
w/o Occupant Classification System:
Detach the band.
Disconnect the connector.
Detach the clamp and claw.
w/ Occupant Classification System:
Disconnect the connector.
Detach the clamp.
Remove the nut and front seat inner belt assembly RH.
Remove the front seat belt anchor plate.