When the engine switch is turned on (IG), the occupant detection ECU sends signals to the airbag sensor assembly to indicate the state of the front seat inner belt assembly RH and also whether the front passenger seat is occupied. The airbag sensor assembly sends those signals to the combination meter assembly via CAN communication. The seat belt warning light on the combination meter assembly illuminates, blinks or turns off in accordance with these signals.
The seat belt warning system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.
The seat belt warning light on the combination meter assembly is used for both the driver seat and front passenger seat. Check that the operation of the seat belt warning light is normal first.
If the seat belt warning light does not operate for both the driver seat and front passenger seat, replace the combination meter.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL
Clear the DTCs.
for Gasoline Model:
for HV Model:
Check for DTCs.
for Gasoline Model:
for HV Model:
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
for Gasoline Model:
for HV Model:
Clear the DTCs.
for Gasoline Model:
for HV Model:
Check for DTCs.
for Gasoline Model:
for HV Model:
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
for Gasoline Model:
for HV Model:
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Occupant Detection / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Passenger Buckle SW | Front passenger buckle switch | Unset, Set or NG | Unset: Seat belt not fastened
Set: Seat belt fastened NG: Data is not determined |
- |
| Tester Display |
|---|
| Passenger Buckle SW |
| Result | Proceed to |
|---|---|
| Unset or Set is displayed on the GTS according to the front passenger seat belt condition | A |
| Unset or Set is not displayed correctly on the GTS according to the front passenger seat belt condition | B |
| NG is displayed on the GTS | C |
A
B
C
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / SRS Airbag / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Right side Buckle SW | RH buckle switch | Unset, Set or NG | Unset: Seat belt not fastened
Set: Seat belt fastened NG: Data is not determined |
- |
| Tester Display |
|---|
| Right side Buckle SW |
| Result | Proceed to |
|---|---|
| Unset or Set is displayed on the GTS according to the front passenger seat belt condition | A |
·
Unset or Set is not displayed correctly on the GTS according to the front passenger seat belt condition ·
NG is displayed on the GTS |
B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B