The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel sub-tank sub-assembly removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the fuel suction plate sub-assembly.
Click hereEngine / Hybrid System>A25A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
77020A
3.REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
83320
4.REMOVE FUEL SENDER GAUGE ASSEMBLY
77103
5.REMOVE FUEL SUB-TANK SUB-ASSEMBLY
Detach the 2 claws and disconnect the fuel suction tube from the fuel sub-tank sub-assembly.
Remove the O-ring from the fuel sub-tank sub-assembly.
Detach the 4 claws and disconnect the sub-assembly support from the fuel sub-tank sub-assembly.
Detach the 2 claws and remove the stay from the fuel sub-tank sub-assembly.
|
Pull |
|
Slide |
Detach the claw and slide the fuel sub-tank sub-assembly and disconnect it from the fuel suction plate sub-assembly.
77103
6.INSTALL FUEL SUB-TANK SUB-ASSEMBLY
| *a | Installation Hole |
| *b | Protrusion |
|
Slide |
Align the protrusion of the fuel sub-tank sub-assembly with the installation hole of the fuel suction plate sub-assembly and slide the fuel sub-tank sub-assembly to install the fuel suction plate sub-assembly.
Attach the 2 claws and install the stay to the fuel sub-tank sub-assembly.
Attach the 4 claws and connect the sub-assembly support to the fuel sub-tank sub-assembly.
Apply gasoline to a new O-ring.
Install the O-ring to the fuel suction tube.
Attach the 2 claws and connect the fuel suction tube to the fuel sub-tank sub-assembly.
83320
7.INSTALL FUEL SENDER GAUGE ASSEMBLY
77020A
8.INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION