This DTC is output when an open circuit or short occurs in the communication line between a front corner ultrasonic sensor (FL sensor) and the clearance warning ECU assembly, or when a malfunction occurs in a front corner ultrasonic sensor (FL sensor) on the front.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE187 | Ultrasonic Sensor (Front Left Corner) Missing Message | Front corner ultrasonic sensor (FL sensor) lost communication | ·
Front corner ultrasonic sensor (FL sensor) ·
Harness or connector ·
Clearance warning ECU assembly |
Perform registration after replacing or removing and installing the ultrasonic sensor or clearance warning ECU assembly.
If a DTC is detected again after the repair, turn the engine switch on (IG) and turn the TOYOTA parking assist-sensor system on, and then clear the DTC.
Initialize the front corner ultrasonic sensors (FL and FR sensors) and front center ultrasonic sensors (FLC and FRC sensors).
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Clear the DTCs.
Recheck for DTCs.
| Symptoms | DTC Detection | |||
|---|---|---|---|---|
| C1AE187 | C1AE287 | C1AE387 | C1AE487 | |
| Symptom 1 | Not output | Not output | Not output | Not output |
| Symptom 2 | Not output | Not output | Not output | Output |
| Symptom 3 | Not output | Not output | Output | Output |
| Symptom 4 | Not output | Output | Output | Output |
| Symptom 5 | Output | Output | Output | Output |
| Result | Proceed to |
|---|---|
| Listed under symptom 1 in combination table | A |
| Listed under symptom 2 in combination table | B |
| Listed under symptom 3 in combination table | C |
| Listed under symptom 4 in combination table | D |
| Listed under symptom 5 in combination table | E |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
D
E
Disconnect the H4 clearance warning ECU assembly connector.
Disconnect the B5 front corner ultrasonic sensor (FL sensor) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H4-2 (BOF) - B5-4 (BI) | Always | Below 1 Ω |
| H4-3 (SOF) - B5-5 (SI) | Always | Below 1 Ω |
| H4-4 (E5) - B5-6 (EI) | Always | Below 1 Ω |
| H4-2 (BOF) or B5-4 (BI) - Body ground | Always | 10 kΩ or higher |
| H4-3 (SOF) or B5-5 (SI) - Body ground | Always | 10 kΩ or higher |
| H4-4 (E5) or B5-6 (EI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front corner ultrasonic sensor (FL sensor).
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
Inspect the front corner ultrasonic sensor (FL sensor).
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
Replace the front corner ultrasonic sensor (FL sensor) with a known good one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Clear the DTCs.
Recheck for DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC C1AE187 is output | B |
A
B
for LHD:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING ECU (for LHD)>REMOVAL
for RHD:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING ECU (for RHD)>REMOVAL