Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG CUT-OFF SWITCH › from 2019.02
RM3620E _58 Vehicle Interior _076036 SUPPLEMENTAL RESTRAINT SYSTEMS _0371436 AIRBAG CUT-OFF SWITCH A

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG CUT-OFF SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 69065A 1.INSTALL AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

a.
B525171C01
0,0 0,0 false
V113147

Install in this Direction


Attach the claw to install the airbag cut off switch cylinder sub-assembly.


Hide 55317A 2.INSTALL INSTRUMENT SIDE PANEL RH

Hide 62311B 3.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

The following procedure is for the LH side.

Click hereVehicle Exterior>DOOR / HATCH>FRONT DOOR OPENING TRIM WEATHERSTRIP>INSTALLATION


Hide 4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 65351A 5.INSTALL BATTERY HOLE COVER (for HV Model)

Hide 58416K 6.INSTALL REAR NO. 2 FLOOR BOARD (for HV Model)

Hide 58410B 7.INSTALL DECK BOARD ASSEMBLY (for HV Model)

Hide 10.PERFORM SYSTEM INITIALIZATION AND CALIBRATION