Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Manual Seat) › from 2020.08
RM3620E _58 Vehicle Interior _076405 SEAT _0372016 FRONT SEAT ASSEMBLY(for Manual Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Manual Seat)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative (-) battery terminal Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for HV model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for HV model) (Click here)
Reset back door close position Power back door system (for HV model) (Click here)
Power back door initialization Power door lock control system (Click here)
·

Occupant detection ECU

·

Front passenger seat


Zero point calibration (Occupant classification system)
·

Occupant classification system (for HV model)

·

Passenger airbag ON/OFF indicator

·

Airbag system (Front passenger side)

·

Seat belt warning system (Front passenger)


(Click here)

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.


Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative (-) battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system for A25A-FKS:(Click here)
for M20A-FKS:(Click here)
Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for Gasoline model) (Click here)
Reset back door close position Power back door system (for Gasoline model) (Click here)
Power back door initialization Power door lock control system (Click here)
·

Occupant detection ECU

·

Front passenger seat


Zero point calibration (Occupant Classification System)
·

Occupant classification system (for Gasoline model)

·

Passenger airbag ON/OFF indicator

·

Airbag system (Front passenger side)

·

Seat belt warning system (Front passenger)


(Click here)

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.


CAUTION:
·
B521791

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.



NOTICE:
·

If the front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.

·

Replace any other damaged parts as necessary.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B458500

Be sure to read precaution thoroughly before servicing.



NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 58410B 2.REMOVE DECK BOARD ASSEMBLY (for HV Model)

Hide 58416K 3.REMOVE REAR NO. 2 FLOOR BOARD (for HV Model)

Hide 65351A 4.REMOVE BATTERY HOLE COVER (for HV Model)

Hide 5.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 71910A 6.REMOVE FRONT SEAT HEADREST ASSEMBLY

a.

Remove the front seat headrest assembly from the front seat assembly LH.


Hide 72124 7.REMOVE FRONT OUTER SEAT TRACK BRACKET COVER LH

a.

Operate the seat track adjusting handle and move the front seat assembly LH to the rearmost position.


b.
B521460C01
0,0 0,0 false
V113146

Place Hands Here
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)
V100155

Protective Tape


Using a thin-bladed screwdriver, detach the claw.

HINT:

Tape the thin-bladed screwdriver tip before use.



c.

Place your hands at the position shown in the illustration and slide in the removal direction (2) while pulling in the removal direction (1) to detach the guide and remove the front outer seat track bracket cover LH.


Hide 72124A 8.REMOVE FRONT INNER SEAT TRACK BRACKET COVER LH

HINT:

Use the same procedure described for the front outer seat track bracket cover LH.


Hide 72138N 9.REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH

a.

Operate the seat track adjusting handle and move the front seat assembly LH to the frontmost position.


b.
B521462C01
0,0 0,0 false
V113147

Remove in this Direction
V100155

Protective Tape


Using a thin-bladed screwdriver, detach the claw.

HINT:

Tape the thin-bladed screwdriver tip before use.



c.

Pull in the removal direction shown in the illustration to detach the guide and remove the rear outer seat track bracket cover LH.


Hide 72158E 10.REMOVE REAR INNER SEAT TRACK BRACKET COVER LH

a.
B521464C01
0,0 0,0 false
V113147

Remove in this Direction
V100155

Protective Tape


Using a thin-bladed screwdriver, detach the claw.

HINT:

Tape the thin-bladed screwdriver tip before use.



b.

Pull in the removal direction shown in the illustration to detach the guide and remove the rear inner seat track bracket cover LH.


Hide 11.REMOVE FRONT SEAT ASSEMBLY LH

a.
B521498

Using a T50 "TORX" socket wrench, remove the 2 "TORX" screws.


b.

Operate the seat track adjusting handle and move the front seat assembly LH to the rearmost position.


c.
B521497

Using a T50 "TORX" socket wrench, remove the 2 "TORX" screws.


d.

Operate the seat track adjusting handle and move the front seat assembly LH to the center position.


e.

Operate the reclining adjuster release handle and move the seatback to the upright position.


f.

Tilt the front seat assembly LH backward.

NOTICE:

Be careful not to damage the front seat assembly LH or the interior parts.



g.

Disconnect the front seat airbag assembly LH connector.

B529785C01
3.594,0.104 3.906,0.323 0.313,0.219 12 false *A 0.302,0.104 0.615,0.323 0.313,0.219 12 false *B 6.135,0.542 6.406,0.75 0.271,0.208 12 true *C 0.781,0.479 1.042,0.688 0.26,0.208 12 true *D 1.573,0.188 1.833,0.396 0.26,0.208 12 true *E
*A for Driver Side *B for Front Passenger Side
*C w/ Seat Heater System *D w/ Seat Heater System or w/ Climate Control Seat System
*E w/ Occupant Classification System - -
V100136

Front Seat Airbag Assembly Connector
V100137

Front Seat Cushion Airbag Assembly RH Connector


i.

Push down the white housing lock and slide the yellow CPA in the slide direction (1) as shown in the illustration.

B517372C07
1.76,1.271 2.292,0.958 true 3.552,1.271 4.083,0.958 true 3.354,2.406 3.531,1.688 true 1.49,2.417 1.667,1.698 true 0.771,1.385 1.469,1.396 true 2.333,0.844 2.646,1.042 0.313,0.198 10 false *a 4.094,0.833 4.406,1.031 0.313,0.198 10 false *a 3.281,2.438 3.594,2.635 0.313,0.198 10 false *b 1.427,2.438 1.74,2.635 0.313,0.198 10 false *b 0.563,1.313 0.875,1.51 0.313,0.198 10 false (A)
*a Housing Lock *b Yellow CPA
V113147

Slide in this Direction (1)
V113148

Slide in this Direction (2)


NOTICE:
·

Do not pull while holding the wire harness.

·

Do not try to release the lock while holding down the top of the yellow CPA (A in the illustration), as this prevents the lock from being released.




ii.

Slide the yellow CPA in the slide direction (2) while pushing down the white housing lock again, and disconnect the connector.



h.

for Front Passenger Side, w/ Occupant Classification System:

Disconnect the front seat cushion airbag assembly RH connector.

i.

Slide the slider in the slide direction (1) to release the lock.

B521467C01
1.865,1.198 1.5,1.052 true 3.542,1.156 3.177,1.01 true 1.333,0.896 1.646,1.052 0.313,0.156 10 false *a 2.99,0.896 3.302,1.052 0.313,0.156 10 false *a
*a Slider - -
V113147

Slide in this Direction (1)
V113148

Slide in this Direction (2)


NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



ii.

Slide in the slide direction (2) to disconnect the connector.



i.

Disconnect each connector and detach the clamp under the front seat assembly LH.


j.
B521499

Remove the front seat assembly LH as shown in the illustration.

NOTICE:
·

2 or more people are required when carrying the front seat assembly LH out of the vehicle.

·

Protect the front seat legs.

·

Be careful not to damage the front seat assembly LH, body exterior or interior parts.