The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during lumbar support adjuster assembly removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
for HV Model with Occupant Classification System:
for Gasoline Model with Occupant Classification System:
w/o Occupant Classification System:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If an SRS part is accidentally deployed, it may cause a serious injury.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
2.REMOVE FRONT SEAT ASSEMBLY LH
71868N
3.REMOVE FRONT SEAT FRONT CUSHION SHIELD LH
71812D
4.REMOVE FRONT SEAT CUSHION SHIELD LH
71862
5.REMOVE FRONT SEAT INNER CUSHION SHIELD LH
6.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
7.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
72760D
8.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH
| *A | w/ Climate Control Seat System |
w/o Climate Control Seat System:
Disconnect the connector.
w/ Climate Control Seat System:
Disconnect the 2 connectors.
Detach the clamp.
|
Remove in this Direction |
Detach the clamp.
Pull in the removal direction shown in the illustration to remove the lumbar support adjuster assembly LH.
Remove the 2 front seatback edge protectors together with the lumbar support adjuster assembly LH.
|
Remove in this Direction |
Remove the front seatback felt LH.
85867A
9.REMOVE SEATBACK CLIMATE CONTROL BLOWER LH (w/ Climate Control Seat System)
71587B
10.REMOVE FRONT SEATBACK EDGE PROTECTOR