The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat cushion heater assembly removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
for HV Model with Occupant Classification System:
for Gasoline Model with Occupant Classification System:
w/o Occupant Classification System:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If an SRS part is accidentally deployed, it may cause a serious injury.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
2.REMOVE FRONT SEAT ASSEMBLY LH
71868N
3.REMOVE FRONT SEAT FRONT CUSHION SHIELD LH
71812D
4.REMOVE FRONT SEAT CUSHION SHIELD LH
71862
5.REMOVE FRONT SEAT INNER CUSHION SHIELD LH
6.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
7.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
71072S
8.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
87510L
9.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH
for Standard Seat Type:
w/o Climate Control Seat System:
Remove the 14 tag pins and front seat cushion heater assembly LH from the separate type front seat cushion cover.
Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly LH.
w/ Climate Control Seat System:
Remove the 19 tag pins and front seat cushion heater assembly LH from the separate type front seat cushion cover.
Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly LH.
for Sports Seat Type:
w/o Climate Control Seat System:
Remove the 12 tag pins and front seat cushion heater assembly LH from the separate type front seat cushion cover.
Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly LH.
w/ Climate Control Seat System:
Remove the 19 tag pins and front seat cushion heater assembly LH from the separate type front seat cushion cover.
Be careful not to damage the separate type front seat cushion cover and front seat cushion heater assembly LH.