The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during clutch master cylinder removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
w/o Occupant Classification System: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/o Occupant Classification System)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for M20A-FKS:General>MAINTENANCE>M20A-FKS BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE KNEE AIRBAG ASSEMBLY (for Driver Side)
4.DRAIN CLUTCH FLUID
Wash brake fluid off immediately if it adheres to any painted surface.
31434E
5.DISCONNECT NO. 1 CLUTCH RESERVOIR HOSE
Slide the hose clip and disconnect the clutch reservoir tube from the clutch master cylinder assembly.
Use a container to collect the fluid.
31481
6.DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE
Using a union nut wrench, disconnect the clutch master cylinder to flexible hose tube.
Use a container to collect the fluid.
31453A
7.DISCONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN
31410
8.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
Remove the 2 nuts and clutch master cylinder assembly from the vehicle body.
31415
9.REMOVE CLUTCH MASTER CYLINDER GASKET
Remove the clutch master cylinder gasket from the clutch master cylinder assembly.