Home › Drivetrain › K120 (MULTIDRIVE / CVT) › REVOLUTION SENSOR(NC1 SENSOR) › from 2020.08
RM3620E _52 Drivetrain _076272 K120 MULTIDRIVE / CVT _0371720 REVOLUTION SENSOR(NC1 SENSOR) A

K120 MULTIDRIVE / CVT  REVOLUTION SENSOR(NC1 SENSOR)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission revolution sensor (NC1) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for Gasoline model) (Click here)
Reset back door close position Power back door system (for Gasoline model) (Click here)
Power back door initialization Power door lock control system (Click here)
Transmission valve body assembly
·

Reset transaxle compensation code

·

Perform reset memory

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration

·

Perform road test to allow TCM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


for Initialization:(Click here)
for Registration:(Click here)
CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)
Air bleed oil pump with motor assembly (w/ Stop and Start System) Stop and start system (Click here)

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.


PROCEDURE

Hide 35410J 1.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

Hide 89413S 2.REMOVE TRANSMISSION REVOLUTION SENSOR (NC1)

a.
C399131

Disconnect the transmission revolution sensor (NC1) connector.


b.
C401374

Remove the bolt and transmission revolution sensor (NC1) from the transaxle case sub-assembly.