The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during park/neutral position switch assembly removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
1.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
2.REMOVE BATTERY
89661
3.REMOVE ECM
74404B
4.REMOVE BATTERY CLAMP SUB-ASSEMBLY
33820B
5.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
| *1 | Clip |
| *a | 45° to 60° |
While disengaging the clip as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever together with the clip.
Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.
84540
6.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Disconnect the park/neutral position switch assembly connector.
| *a | Piece of Wood or Equivalent |
Using a piece of wood or equivalent to secure the transmission control shaft lever to prevent it from rotating, remove the nut, washer and transmission control shaft lever from the manual valve lever shaft.
| *1 | Transmission Control Shaft Lever |
| *a | Manual Valve Link Lever Sub-assembly |
| *b | Manual Valve |
If the transmission control shaft lever is not secured when loosening the nut, the manual valve link lever sub-assembly may separate from the manual valve.
Remove the 2 bolts and park/neutral position switch assembly from the transaxle case sub-assembly.
Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the manual valve lever shaft. Be sure to remove the park/neutral position switch assembly straight along the manual valve lever shaft while being careful not to deform the plate spring that supports the manual valve lever shaft. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.