The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear No. 1 differential mount cushion removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
41110
1.REMOVE TORQUE VECTORING DIFFERENTIAL CARRIER ASSEMBLY (for Torque Vectoring Differential)
41110
2.REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY (except Torque Vectoring Differential)
41651
3.REMOVE REAR NO. 1 DIFFERENTIAL MOUNT CUSHION
Using SST, remove the rear No. 1 differential mount cushion.
| *1 | Rear Suspension Member Sub-assembly | - | - |
| *a | Turn | *b | Hold |
|
Turning Direction |
|
Front of Vehicle |
|
SST Bolt Position | - | - |
Do not bring SST into contact with the rear suspension member sub-assembly.
Before using SST, apply grease to SST bolt.
Set SST in the correct direction.
Do not tilt the bolt of SST.
Do not reuse the rear No. 1 differential mount cushion.