Home › Power Source / Network › M20A-FKS (BATTERY / CHARGING) › GENERATOR(for 100 A, 130 A Type) › from 2020.08
RM3620E _57 Power Source / Network _076182 M20A-FKS BATTERY / CHARGING _0371081 GENERATOR(for 100 A, 130 A Type) A

M20A-FKS BATTERY / CHARGING  GENERATOR(for 100 A, 130 A Type)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the generator assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for Gasoline model) (Click here)
Reset back door close position Power back door system (for Gasoline model) (Click here)
Power back door initialization Power door lock control system (Click here)

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 17750A 3.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 16361A 4.REMOVE V-RIBBED BELT

Hide 27020 5.REMOVE GENERATOR ASSEMBLY

a.
A432016

Disconnect the generator assembly connector.


b.

Open the terminal cap.


c.

Remove the nut and disconnect the wire harness from terminal B.


d.

Remove the bolt and separate the wire harness clamp bracket from the generator assembly.


e.
A432017

Remove the 2 nuts, bolt and generator assembly.