The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
27020
1.REMOVE GENERATOR ASSEMBLY
for 100 A, 130 A Type:
Click herePower Source / Network>M20A-FKS (BATTERY / CHARGING)>GENERATOR(for 100 A, 130 A Type)>REMOVAL
for 150 A Type:
Click herePower Source / Network>M20A-FKS (BATTERY / CHARGING)>GENERATOR(for 150 A Type)>REMOVAL
89615
2.REMOVE KNOCK CONTROL SENSOR
Disconnect the knock control sensor connector.
Remove the bolt and knock control sensor from the cylinder block sub-assembly.
If the knock control sensor has been struck or dropped, replace it.