Home › Engine / Hybrid System ยท CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DYNAMIC LASER CRUISE CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the dynamic radar cruise control system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding.

    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)*
    1. Use the Techstream to check for normal function of CAN communication system.

      1. Perform bus check (communication malfunction DTC).

      2. Perform bus check (communication bus check).
        Result 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4. CHECK FOR DTC*
      Refer to DTC Check/Clear (Click here).
    1. Check for DTC and note any codes that are output.

    2. Clear the DTC.

    3. Recheck for DTC. Try to prompt the DTC by simulating the original activity that the DTC suggests.
      Result 
      Result
      Proceed to
      DTC does not reoccur
      A
      DTC reoccur
      B



    B.
    Go to step 7
    A


    5.PROBLEM SYMPTOMS TABLE
      Refer to the Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B


    B.
    Go to step 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here).

    2. Data List/Active Test (Click here).


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NOTICE:
      1. When the distance control ECU is replaced with a new one, initialization must be performed (Click here).
      2. When the radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed (Click here).


    NEXT


    8.CONFIRMATION TEST

      NEXT

      END