AUDIO AND VISUAL SYSTEM > Stereo Component Amplifier Communication Error |
| 1.IDENTIFY COMPONENT SHOWN BY SUB-CODE |
Enter the diagnostic mode.

Press the preset switch "3" to change to "Detailed Information Mode".
Identify the component shown by the sub-code.
| NEXT | |
| 2.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE |
Inspect the power source circuit of the component shown by the sub-code.
If the power source circuit is operating normally, proceed to the next step.
| Component | Proceed to |
| "Bluetooth" handsfree module (19D) | Radio Receiver Power Source Circuit (Click here) |
| Radio receiver (190) | Radio Receiver Power Source Circuit (Click here) |
| Television display (1B0)* | Television Display Assembly Power Source Circuit (Click here) |
| NEXT | |
| 3.INSPECT RADIO RECEIVER ASSEMBLY |
![]() |
Disconnect the I4 and I8* radio receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I4-5 (ATX+) - I4-15 (ATX-) | Always | 60 to 80 Ω |
| I8-9 (TXM+) - I8-10 (TXM-)* | Always | 60 to 80 Ω |
Reconnect the radio receiver assembly connectors.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - COMPONENT SHOWN BY SUB-CODE) |

Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the stereo component amplifier assembly and the component shown by the sub-code.
Disconnect all connectors between the stereo component amplifier assembly and the component shown by the sub-code.
Check for an open or short in the AVC-LAN circuit between the stereo component amplifier assembly and the component shown by the sub-code.
|
| ||||
| OK | |
| 5.REPLACE COMPONENT SHOWN BY SUB-CODE |
Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.
|
| ||||
| OK | ||
| ||