Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > EPS Warning Light Circuit

for Preparation Click here


DESCRIPTION

The power steering ECU is connected to the combination meter via CAN communication. If the power steering ECU detects a malfunction, the EPS warning light comes on. At this time, vehicle enters a fail-safe mode.

WIRING DIAGRAM


C179952E01


INSPECTION PROCEDURE

1.INSPECT CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY)


    C179928E02
  1. Disconnect the power steering ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H38-6 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
INSPECT IG POWER SOURCE CIRCUIT (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND)


    C179928E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H38-2 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK EPS WARNING LIGHT USING TECHSTREAM (COMBINATION METER)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON and the Techstream on.

  1. Perform the Active Test of the combination meter (meter CPU) using the Techstream (Click here).

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. EPS
    EPS warning light
    ON or OFF
    Perform the test with the vehicle stopped and engine idling

  1. Check that the EPS warning light turns on and off in the combination meter using the Techstream.

    OK:
    The EPS warning light turns on and off in accordance with the Techstream operation.



NG
INSPECT COMBINATION METER (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)