Home › Power Source / Network ยท NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here


HINT:
If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to "See page" below.


CAN Communication System 
DTC Code
Detection Item
Trouble Area
See page
U0199
Lost Communication with "Door Control Module A"
- Power source circuit of outer mirror control ECU
- Outer mirror control ECU
- Outer mirror control ECU branch wire or connector
Click here
U0208
Lost Communication with "Seat Control Module A"
- Power source circuit of power seat control ECU
- Power seat control ECU
- Power seat control ECU branch wire or connector
Click here
U0230
Lost Communication with Rear Gate Module
- Power source circuit of power back door ECU
- Power back door ECU
- Power back door ECU branch wire or connector
Click here
U1002
Lost Communication with Gateway Module
- MS bus circuit
- Outer mirror control ECU branch wire or connector
- Power seat control ECU branch wire or connector
- Multiplex tilt and telescopic ECU branch wire or connector
- Power back door ECU branch wire or connector
- Main body ECU main wire or connector
- Combination meter ECU main wire or connector
- Outer mirror control ECU
- Power seat control ECU
- Multiplex tilt and telescopic ECU
- Power back door ECU
- Main body ECU
- Combination meter ECU
- No. 3 junction connector
- No. 4 junction connector
Click here
U1115
Lost Communication with Tilt and Telescopic Module
- Power source circuit of multiplex tilt and telescopic ECU
- Multiplex tilt and telescopic ECU
- Multiplex tilt and telescopic ECU branch wire or connector
Click here