Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Stereo Component Amplifier Communication Error

for Preparation Click here


WIRING DIAGRAM


E189530E10


INSPECTION PROCEDURE

1.IDENTIFY COMPONENT SHOWN BY SUB-CODE


  1. Enter the diagnostic mode.


    E146440E06

  1. Press the preset switch "channel 3" to change to "Detailed Information Mode".

  1. Identify the component shown by the sub-code.

    HINT:
    1. "190 (radio receiver assembly)" is the component shown by the sub-code in the example shown in the illustration.
    1. For details of the DTC display, refer to "DTC Check/Clear" (Click here).


NEXT


2.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.
    If the power source circuit is operating normally, proceed to the next step.

    HINT:
    The "Bluetooth" handsfree module is built into the radio receiver.


    Component Table 
    Component
    Proceed to
    "Bluetooth" handsfree module (19D)
    Radio Receiver Power Source Circuit (Click here)
    Satellite radio tuner (1F1)*3
    Radio receiver assembly (190)
    Television display assembly (1B0)*1
    Television Display Assembly Power Source Circuit (Click here)
    Multi-media interface ECU*2
    Multi-media Interface ECU Power Source Circuit (Click here)
    1. *1: w/ Rear Seat Entertainment System
    2. *2: w/ USB Audio System
    3. *3: w/ Satellite Radio


NEXT


3.INSPECT RADIO RECEIVER ASSEMBLY


    E145834E18
  1. Disconnect the I4 and I8* radio receiver assembly connectors.

    1. *: w/ USB Audio System

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I4-5 (ATX+) - I4-15 (ATX-)
    Always
    60 to 80 Ω
    I8-9 (TXM+) - I8-10 (TXM-)*
    Always
    60 to 80 Ω

    1. *: w/ USB Audio System



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER - COMPONENT SHOWN BY SUB-CODE)

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  1. For details of the connectors, refer to "Terminals of ECU" (Click here).

  1. Referring to the wiring diagram below, check the AVC-LAN circuit between the stereo component amplifier assembly and the component shown by the sub-code.

    1. Disconnect all connectors between the stereo component amplifier assembly and the component shown by the sub-code.

    2. Check for an open or short in the AVC-LAN circuit between the stereo component amplifier assembly and the component shown by the sub-code.

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)
OK

END