Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)

AUDIO AND VISUAL SYSTEM (for Radio and Display Type) > Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter

for Preparation Click here


DESCRIPTION

Audio function:
This circuit is necessary for the automatic sound levelizer (ASL) built into the radio and display receiver assembly.
ASL function:
Speed signals are received from the combination meter assembly and used for the ASL.
The ASL function automatically adjusts the sound volume in order to maintain clear audio sound even when vehicle noise increases (as vehicle noise increases, the volume is turned up, etc.).

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU connected to the combination meter assembly, and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls its respective systems based on the pulse signal.
  2. If a short occurs in any of the ECU or in the wire harness connected to an ECU, related components will not operate normally.


WIRING DIAGRAM


E280104E05


INSPECTION PROCEDURE

1.CHECK VEHICLE SIGNAL


    E286178
  1. Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal Check Mode in Operation Check (Click here)]

  1. While driving the vehicle, compare the value of "SPEED" to the reading on the speedometer.

    1. Check if these readings are almost equal.

      OK:
      Vehicle speed displayed on the "Vehicle Signal Check Mode" screen is almost the same as the reading on the speedometer.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)
  1. Disconnect the I58 radio and display receiver assembly connector.

  1. Disconnect the H37 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I58-17 (SPD) - H37-35 (+S)
    Always
    Below 1 Ω
    I58-17 (SPD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT COMBINATION METER ASSEMBLY (SPEED SIGNAL)


    E190309E23
  1. Check the input waveform.

    1. Remove the combination meter assembly with the connector(s) still connected.

    2. Connect an oscilloscope to terminal H37-35 (+S) and body ground.

    3. Turn the ignition switch to ON.

    4. Check the signal waveform according to the condition(s) in the table below.
      Measurement Condition 
      Item
      Condition
      Terminal No. (Symbol)
      H37-35 (+S) - Body ground
      Tool setting
      5 V/DIV., 20 ms./DIV.
      Condition
      Being driven at approximately 20 km/h (12 mph)

      OK:
      The waveform displayed is as shown in the illustration.

      Text in Illustration 
      *a
      Component with harness connected
      (Combination Meter Assembly)

      HINT:
      When the system is functioning normally, one wheel revolution generates 4 pulses.
      As the vehicle speed increases, the width indicated by (A) in the illustration narrows.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)